DT-1/24V Duct Thermostat
Product Code: DT-1/24V
The DT-1/24V duct thermostat delivers accurate electronic control of temperaure levels in HVAC ventilation ducts. Capable of switching loads of up to 10A at 250V AC, it is ideally suited to the control of heating, cooling and ventilation quipment; such as heaters, fans, boost controls, override controls, alarms, etc. The duct termostat is powered from a 24V AC or DC supply.
The DT-1 is calibration-free and accurate to within 2°C. The high-accuracy temperature sensor is housed in a robust, corrosion-proof 200mm* probe, delivering consistent accuracy and maintenance free** operation.
The DT-1 regulates to a fully adjustable temperature set-point between +12°C and +26°C, combined with an adjustable temperature hysteresis (differential) of anything between 0.25°C and 4°C.
The duct thermostat design allows for easy installation directly to the exterior of flat-sided ductwork using self-tapping screws. A 16mm dia hole will be required for the temperartue sensor probe to protrude through into the duct. The unit comes complete with a cable gland in the base for tidy and secure cabling. Alternatively if direct connection to electrical conduit is desired, this may be removed and exchanged for a suitable conduit connector (with M20 thread).
** Maintenance free in clean airflow. Any accumulation of dust or debris on the protective mesh filter may be removed by vacuuming.
Select between the following options:
DT-1/24V/50 – 50mm probe length
DT-1/24V/100 – 100mm probe length
DT-1/24V/200 – 200mm probe length
*Other lengths available on request, please contact us on 0333 66 1176 or email email@example.com
Download product datasheet (2340Kb)
- 10 Amp switching capacity
- 24 Volt AC/DC power supply
- 3 year guarantee
- Energy-saving product
- Money-saving product
- On / Off control
- Standard - 230V
- Suitable for heating control
- Suitable for ventilation control